CSSBB Dumps With Exact Questions and Answers

The process capability index Ppk measures how well a process is performing relative to its specification limits while accounting for how centered the process mean is. It is calculated using the formulas:

First determine the specification limits from the tolerance 5.2 ± 0.3 :

USL = 5.2 + 0.3 = 5.5

LSL = 5.2 − 0.3 = 4.9

Next compute both capability sides.

Upper side:

Lower side:

Ppk takes the minimum of these two values because capability is limited by the nearest specification limit.

Thus, the correct answer is A (0.625) . The process mean is closer to the upper specification limit, which reduces capability on that side and determines the overall Ppk value.

The correct answer is A. Single-minute exchange of dies (SMED) . In the CSSBB Improve-phase material, SMED is presented under Lean methods / cycle time reduction . The source explains that setup reduction, also called SMED, is one of the most important Lean tools and is specifically intended to take long setup changes and reduce them to minutes . It also states that reducing setup times expands production capacity, reduces inventories, increases flexibility, and improves responsiveness.

Because setup time is a major contributor to lead time and cycle time, reducing it directly supports faster flow and shorter overall process time. The other options do not fit this purpose. Double sampling is a sampling-plan concept, WIP holding areas generally increase delay rather than reduce cycle time, and SPC is used to monitor variation and stability rather than directly shorten cycle time. In Lean Six Sigma, SMED is a classic speed and flow improvement tool. Therefore, the verified CSSBB-based answer is A. Single-minute exchange of dies (SMED) .

The correct answer is A. Performance variation versus manufacturing cost . In the CSSBB DFSS material, tolerance design is presented as part of robust design and is used after parameter design. The source explains that tolerance specifications are set before going to manufacturing and that the quality loss function is used to determine economical tolerance levels. The CSSBB questions section also notes that at the tolerance stage, the use of more expensive components or processes may be considered.

This shows the central trade-off in tolerance design: tighter tolerances reduce variation in performance and quality loss, but they usually increase manufacturing cost because they demand better materials, tighter control, or more capable processes. If tolerances are too loose, product performance varies more and customer or societal loss rises. If tolerances are too tight, production cost rises sharply. Therefore, tolerance design is fundamentally about balancing performance variation against manufacturing cost to achieve an economically robust design. That makes A the verified CSSBB answer.