F5CAB1 Dumps With Exact Questions and Answers

BIG-IP hardware platforms use chassis LEDs to indicate system health states.

Asolid yellow status LEDtypically indicates awarning condition, such as:

A non-critical hardware alert

A temperature threshold nearing limit

A minor fan or sensor irregularity

Other non-fatal environmental or system conditions

This state reflects awarning-level alarm, meaning the unit is operational but requires investigation.

Why the other options are incorrect

A. Halted or EUD mode

This is associated with different LED patterns (usually flashing conditions or specific color codes), not a solid yellow status LED.

B. Standby in device group

HA state is not indicated by the chassis status LED.

Standby status is alogicaldevice state, not a hardware LED state.

D. Power supply failure

Power supply indicators use separate LEDs located on each power module (usually flashing amber/red), not the system status LED.

Thus, asolid yellow status indicatorsignifies awarning-level alarm.

Provisioning determines:

Which BIG-IP modules are enabled (LTM, ASM, APM, AFM, DNS, etc.)

Their provisioning levels (None, Minimal, Nominal, Dedicated)

Two accurate ways to view provisioning settings are:

A. GUI — System → Resource Provisioning → Module Allocation

This is the primary GUI screen showing:

All modules

Their provisioning level

System resource distribution impact

Administrators commonly use this page to confirm or change module provisioning.

D. TMSH — list /sys provision

This tmsh command displays each module and its provisioning level:

sys provision ltm { level nominal }

sys provision asm { level none }

This is the authoritative CLI method for checking module provisioning configurations.

Why the other options are incorrect:

B. show /sys provision

Showsruntimeinformation butnot the actual configuration levels.

list is the correct command for configuration details.

C. Statistics → Module Statistics

Shows performance statistics, NOT provisioning status.

Therefore, the correct responses areAandD.

TheService Check Datedetermines whether a particular software version is allowed to run under the device’s license.

When installing or upgrading TMOS, the installer checks theService Check Datestored in the BIG-IP license file.

If the license date isolderthan the minimum required for the target version, the software installation isblocked.

This check happensspecifically during a software install, not during routine device operations.

Editing virtual servers or system startup do not trigger this validation.

Thus, the enforcement happensduring software installation.