Navigate to the network-interface configuration element and set the sub-port-id parameter to 12.

Navigate to the network-interface configuration element and set the sub-port-id parameter to 0.

Navigate to the phy-interface configuration element and configure the hip-id parameter.

Navigate to the phy-interface configuration element and configure the pri-utility-address parameter.

Navigate to the network-interface configuration element and configure the name parameter.

The default community strings are acme and packet.

The default community strings are public and private.

Community strings are in passive mode.

There are no default community strings.

Only one trap receiver can be configured.

Secondary only

Active node that no longer has a heartbeat

Standby only

Active only

Standby or Active

Navigate to the session-agent configuration element and set the strategy parameter to sequential .

Navigate to the session-agent configuration element and set the strategy parameter to propdist .

Navigate to the session-agent configuration element and set the strategy parameter to hunt .

Navigate to the session-agent configuration element and set the strategy parameter to roundrobin .

Navigate to the session-agent configuration element and set the strategy parameter to leastbusy .

by running the notify berpd force command

by running the show sipd endpoint-ip < phone number > command

by checking the sip-manipulation configuration element used for routing from the backbone realm to the access realm

by checking the registration-cache configuration element used for routing from the access realm to the backbone realm

by checking the local-policy configuration element used for routing from the access realm to the backbone realm

from the superuser mode, by executing the remove user < index number > command

from the user mode, by executing the kill < index number > command

from the superuser mode, by executing the remove user < username > command

from the superuser mode, by executing the kill < index number > command

from the user mode, by executing the remove user < index number > command

the subscription to a SIP presence service

the generation of a remote ring-back tone

the generation of a local ring-back tone

the establishment of a SIP session

the termination of a SIP session

There are no major concerns with NATs.

NATs block unsolicited incoming signaling and media.

NATs block unsolicited incoming signaling but allow incoming media.

NATs pinholes expire after a configurable time.

NATs devices can be overloaded by incoming registrations.

SIP does not provide for resource reservation.

SIP defines native methods for negotiating media streams.

A SIP transaction occurs between a client and a server.

To set up a voice session, SIP relies on protocols such as SDP and RTP.

SIP signaling can only be used for voice over IP thereby limiting its use as a general signaling protocol.

The two nodes have different health scores.

The training1 peer is the standby node.

The switchover berpd force command was executed to do a manual failover.

The training6 peer is the active node.

The training6 peer will wait 1050 ms before considering the training1 peer out of service.