201 F5 TMOS Administration exact Exam Questions

TMOS Administration

Last Update 10 hours ago Total Questions : 254

The TMOS Administration content is now fully updated, with all current exam questions added 10 hours ago. Deciding to include 201 practice exam questions in your study plan goes far beyond basic test preparation.

You'll find that our 201 exam questions frequently feature detailed scenarios and practical problem-solving exercises that directly mirror industry challenges. Engaging with these 201 sample sets allows you to effectively manage your time and pace yourself, giving you the ability to finish any TMOS Administration practice test comfortably within the allotted time.

Question # 61

A new BIG-IP VE is deployed with default settings. The BIG-IP Administrator completes the setup utility in the Configuration Utility. The internal self IP address fails to respond to a ping request. What is a possible cause of this issue?

Port lockdown on internal self IP is set to Allow None

Route is NOT assigned to internal self IP.

Internal interface VLAN is set to untagged

Internal interface VLAN is set to tagged

Question # 62

Where is the loadbalancing mode specified?

within the pool definition

within the node definition

within the virtual server definition

within the pool member definition

Question # 63

A standard virtual server is defined with a pool and a SNAT using automap. All other settings for the virtual server are at defaults. When client traffic is processed by the BIG-IP, what will occur to the IP addresses?

Traffic initiated by the pool members will have the source address translated to a self-IP address but the destination address will not be changed.

Traffic initiated to the virtual server will have the destination address translated to a pool member address and the source address translated to a self-IP address.

Traffic initiated by selected clients, based on their IP address, will have the source address translated to a self-IP address but the destination will only be translated if the traffic is destined to the virtual server.

Traffic initiated to the virtual server will have the destination address translated to a pool member address and the source address translated to a self-IP address. Traffic arriving destined to other destinations will have

the source translated to a self-IP address only.

Question # 64

A BIG-IP Administrator is working with a BIG-IP device and discovers that one of the Interfaces on a

Trunk is DOWN.

What is the reason for this Interface status?

The switch is NOT connected to the Interface

There is NO transceiver installed on the Interface

There is NO default route configured for this trunk

The media speed of the interface has NOT been set

Question # 65

Refer to the exhibit.

How long will the persistence record remain in the table?

180 seconds after the last packet

180 seconds after the initial table entry

300 seconds after the initial table entry

300 seconds after the last packet

Question # 66

A BIG-IP Administrator is informed that traffic on Interface 1.1 is expected to increase over the maximum bandwidth capacity on the link. There is a single VLAN on the Interface. What should the 8IG-IP Administrator do to increase the total available bandwidth?

Assign two Interfaces to the VLAN

Set the media speed of Interface 1.1 manually

Create a trunk object with two Interfaces

Increase the MTU on the VLAN using Interface 1.1

Question # 67

Refer to the exhibit.

Why is the virtual server responsive to incoming connections?

The pool member is disabled

The pool member monitor failed

The node is disabled.

The node monitor failed

Question # 68

How is MAC masquerading configured?

Specify the desired MAC address for each VLAN for which you want this feature enabled.

Specify the desired MAC address for each selfIP address for which you want this feature enabled.

Specify the desired MAC address for each VLAN on the active system and synchronize the systems.

Specify the desired MAC address for each floating selfIP address for which you want this feature enabled.

Question # 69

A BIG-IP Administrator defines a device Self IP . The Self IP is NOT reachable from the network. What should the BIG-IP Administrator verify first?

The correct interface has been selected.

The correct VLAN has been selected.

Verify if auto last hop is disabled.

The correct Trunk has been selected.

Question # 70

As a part of the Setup Utility, the administrator sets the host name for the BIG IP. What would be the result if the two systems in a redundant pair were set to the same host name?

Host names do not matter in redundant pair communication.

In a redundant pair, the two systems will always have the same host name. The parameter is synchronized between the systems.

The first time the systems are synchronized the receiving system will be assigned the same self-IP addresses as the source system.

When the administrator attempts to access the configuration utility using the host name, they will always connect to the active system.