NS0-593 Dumps With Exact Questions and Answers

= According to the NetApp Knowledge Base 1 , while Cloud Volumes ONTAP supports FlexGroup volumes, Cloud Manager does not. If you create a FlexGroup volume from System Manager or from the CLI, then you should set Cloud Manager’s Capacity Management mode to Manual. Automatic mode might not work properly with FlexGroup volumes.  The other options are incorrect because Cloud Volumes ONTAP does support FlexGroup volumes 2 , the Capacity Management Mode should not be set to Automatic, and Cloud Manager is not required to provision the FlexGroup volume 3 .  References  =  1 ,  2 ,  3

To access a LUN on a FAS 8300 system from a VMware ESXi server through the FC protocol, the customer must configure the FC service on the SVM that owns the LUN. The FC service enables the SVM to act as an FC target and communicate with the FC initiators on the host. Without the FC service, the LUN will not be visible to the host, even if the LUN is mapped to an igroup and the FC LIFs are up. The exhibit shows that the FC service is not configured on the SVM, as the output of the command  vserver fcp initiator show -vserver SVM1  is empty. Therefore, the reason for the problem is that the FC service has not been configured on the SVM.  References  =  Configure an SVM for FC ,  Create an FC protocol service ,  Single IQN iSCSI session with ESXi on ONTAP when igroup has two IQNs

 To enable DDNS updates to work, two actions should be performed:

Remove the NFS protocol from the cifs_01 data LIF.  This is because DDNS updates are only supported for LIFs that have only one data protocol enabled 1 . The cifs_01 LIF has both NFS and CIFS protocols enabled, which prevents it from registering its DNS record dynamically. By removing the NFS protocol from the cifs_01 LIF, it will become eligible for DDNS updates.

Enable the -is-enabled parameter for the SVM DDNS services.  This is because the -is-enabled parameter controls whether the SVM sends DDNS updates to the DNS servers 2 . The exhibit shows that the -is-enabled parameter is set to false for the svm1 SVM, which means that it does not send any DDNS updates. By enabling the -is-enabled parameter, the SVM will start sending DDNS updates for its eligible LIFs.  References :

1 : Configure dynamic DNS services 3

2 : Manage DNS/DDNS services with System Manager 4