Exact2Pass
Last Update 23 hours ago Total Questions : 120
The Certified Wireless Network Administrator content is now fully updated, with all current exam questions added 23 hours ago. Deciding to include CWNA-106 practice exam questions in your study plan goes far beyond basic test preparation.
You'll find that our CWNA-106 exam questions frequently feature detailed scenarios and practical problem-solving exercises that directly mirror industry challenges. Engaging with these CWNA-106 sample sets allows you to effectively manage your time and pace yourself, giving you the ability to finish any Certified Wireless Network Administrator practice test comfortably within the allotted time.
What features were introduced in the IEEE 802.11h amendment in order to uphold regulatory requirements for 5 GHz operation? (Choose 2)
You have been sent as a consultant to a customer site that is experiencing problems with some 2.4 GHz clients on their 802.11a/g/n/ac network. After collecting information from the company about the problem, your initial troubleshooting step is to find a client device experiencing performance problems and observe its 802.11 frame exchanges in a protocol analyzer. The retransmission rate for that client is 65% instead of the company’s baseline, which is 9%.
Based on this information, what troubleshooting step should follow to isolate the problem?
What problems may exist for a multiple channel architecture (MCA) WLAN when its APs are all operating at full power (typically 100mW)? (Choose 2)
A WLAN transmitter that emits a 200 mW signal is connected to a cable with 3 dB loss.
If the cable is connected to an antenna with 10 dBi gain, what is the EIRP at the antenna element?
When planning an access point deployment that utilizes Power over Ethernet (PoE) switches at the network edge, what design decision could adversely affect the operation of 802.3-2012, Clause 33 APs?
The IEEE 802.11-2012 standard requires VHT capable devices to be backward compatible with devices using which other 802.11 physical layer specifications (PHYs)? (Choose 2)
What WLAN system feature is required to produce a scenario with the following configuration on a single access point? (Choose 2)
1. SSID = Guest / BSSID = AA:AA:AA:AA:AA:AA /
VLAN = 22 / Subnet = 192.168.22.0 / RF Channel = 6
2. SSID = Corporate / BSSID = BB:BB:BB:BB:BB:BB /
VLAN = 33 / Subnet = 192.168.33.0 / RF Channel = 6 / User Type A
3. SSID = Corporate / BSSID = BB:BB:BB:BB:BB:BB /
VLAN = 44 / Subnet = 192.168.44.0 / RF Channel = 6 / User Type B
What term describes the effect of increasing the intensity of an RF wave with an antenna by focusing the energy in a specific direction?
What HT technology requires MIMO support on both the transmitter and receiver?
Which data rate is supported by 802.11g radios that is not supported by 802.11a radios?
