An Email Address only

An SNMP receiver only

An SNMP receiver only tied to a set of Host Groups

An Email Address and/or one or two SNMP receivers optionally tied to a set of Host Groups

An Email Address and/or one or two SNMP receivers optionally tied to a set of User Accounts

A User Account

The Network Operations Dashboard

The " Interface Information " Report available from the " Reports- > Shortcuts " page

The " System > Information " page

The " System > Devices/Interfaces " page

IP Addresses, Port Numbers, Protocol, TCP Flags, DSCP Marking, number of bits, number of packets, retransmitted bits

IP Addresses, Port Numbers, Protocol, TCP Flags, DSCP Marking, number of bits, number of packets, inbound/outbound interface ID

IP Addresses, MAC Addresses, Port Numbers, Protocol, DSCP Marking, number of bits, number of packets

IP Addresses, Port Numbers, Protocol, Round Trip Time, DSCP Marking, number of bits, number of packets

IP Addresses, Port Numbers, Protocol, Packet Latency, DSCP Marking, number of bits, number of packets

Apply a View on the live interface and then start a Capture Job on the capture port to analyze traffic later.

Start a Capture Job on the capture port with a BPF filter and apply a View on the live interface for the same capture job.

Start a Capture Job on the capture port, apply a View on the live interface and create a trace clip for the time window of interest.

Never create a Capture Job to prevent packet drops.

Watched list as a bar chart

Watched list as a stacked area chart

Watched list as a line graph

Watched list as a pie chart

Top list as a bar chart

Interface centric

Application centric

Host centric

Port centric

The Cascade Profiler does not have two approaches

It is used to export NetFlow for intra-VLAN traffic.

It is used to capture packets when no SPAN ports are available on the switch

It is used to collect SNMP statistics from VLAN traffic

It is used to configure SPANs remotely using network management tools

It is used to allow SNMP write Access to a switch or router

Cascade Gateway ' s poll via SNMP sources of Netflow, while Cascade Profiler, Cascade Gateway and Cascade Sensor sync NTP from a common source.

Cascade Profiler ' s poll via SNMP sources of Netflow, while Cascade Profiler, Cascade Gateway and Cascade Sensor sync NTP from a common source.

Cascade Profiler, Cascade Gateway and Cascade Sensor sync NTP from different sources, while Cascade Profiler ' s poll via SNMP sources of Netflow.

Cascade Profiler, Cascade Gateway and Cascade Sensor sync NTP from different sources, while Cascade Gateway ' s poll via SNMP sources of Netflow.

Cascade Profiler does all SNMP polling and is also the source of all NTP.

You can connect directly to the Cascade Shark with Cascade Pilot to begin analysis.

You can connect directly to the Cascade Shark with Cascade Gateway to begin analysis.

You can start analysis on the Cascade Profiler based upon flow data that has been sent from Cascade Shark to Cascade Profiler.

You can export data from a capture job directly to a packet capture (pcap) file and open in any tool that accepts pcap format.

You can start by loading views of the data from the Cascade Shark Appliance Web GUI before export to Wireshark.

Send an email when the traffic reaches at least 1MB/sec.

Notify all Cascade Pilot users connected to a specific Cascade Shark appliance when a specified traffic event occurs.

Create a Web traffic report with a specific time window.

Start a Capture Job each time the VoIP traffic goes below 2MB/sec.