300-515 Cisco Implementing Cisco Service Provider VPN Services (300-515 SPVI) exact Exam Questions

Implementing Cisco Service Provider VPN Services (300-515 SPVI)

Last Update 4 hours ago Total Questions : 71

The Implementing Cisco Service Provider VPN Services (300-515 SPVI) content is now fully updated, with all current exam questions added 4 hours ago. Deciding to include 300-515 practice exam questions in your study plan goes far beyond basic test preparation.

You'll find that our 300-515 exam questions frequently feature detailed scenarios and practical problem-solving exercises that directly mirror industry challenges. Engaging with these 300-515 sample sets allows you to effectively manage your time and pace yourself, giving you the ability to finish any Implementing Cisco Service Provider VPN Services (300-515 SPVI) practice test comfortably within the allotted time.

Question # 11

With Layer 3 MPLS VPN implementations on Cisco IOS XR PE routers, an interface is assigned to a VRF using the vrf command in which configuration mode?

RP/0/RP0/CPU0:PE(config-bgp)#

RP/0/RP0/CPU0:PE(config-if)#

RP/0/RP0/CPU0:PE(config-bgp-af)#

RP/0/RP0/CPU0:PE(config-vrf)#

Question # 12

While configuring the VRF Selection feature, you get an error message after typing the below statement:

Router(config)#no vrf selection source 172.16.0.0 255.255.0.0 v rf VRF1

Which action caused this message?

the entry of an inconsistent IP address and mask for VRF Selection

an attempt to configure a VRF instance on an interface that already has VRF Selection configured

an attempt to remove a VRF Selection entry that does not exist

an attempt to configure a VRF Selection table that does not exist

Question # 13

Which utility can you use to validate an LSP in an MPLS environment?

uRPF

MPLS LSP ping

logging

RSVP

Question # 14

Which two frames can be configured on an Ethernet flow point? (Choose two.)

of a specific VLAN

with different type of service values

with identical type of service value

with different class of service values

with no tags

Question # 15

An engineer needs to improve MPLS network management by implementing a set of tools to support the NOC engineers in troubleshooting network failures. Which feature should the engineer implement to check the connectivity of the MPLS LSP between the ingress and egress PE routers?

MPLS OAM

MPLS-TP

LDP autodiscovery

extended ping

Question # 16

Refer to the exhibit.

If the two devices are operating normally, which two conclusions can you draw from this configuration? (Choose two.)

CE1 must use OSPF to establish a neighbor relationship with PE1.

PE1 labels the routes it learns from CE1 with the route-target 222:2 and shares them with its VPNv4 peers.

PE1 labels the routes it learns from CE1 with the route-target 111:1 and shares them with its VPNv4 peers.

The PE-CE routes between the devices are being exchanged by OSPF

CE1 is supporting CSC.

Question # 17

An ISP provides a major client MPLS VPN for managed services. The MPLS engineering team needs to use the advanced VPN feature of selective VRF import so that only specific prefixes are present in the required VPNs.

Which aspect of this feature must the team consider?

A route must pass the import route map first and then the route target import filter.

The routers that are imported in the VRF can be BGP and IGP routes, so other match conditions in the route map, besides communities, can be used.

The import-map command is applied under the PE interface that connects to the CE router.

A route is imported into the VRF only when at least one RT that is attached to the route matches one RT that is configured in the VRF and the route is permitted by the import route map.