Summer Sale Special 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: ex2p65

Exact2Pass Menu

RUCKUS Certified Networking Implementer Exam

Last Update 19 hours ago Total Questions : 54

The RUCKUS Certified Networking Implementer Exam content is now fully updated, with all current exam questions added 19 hours ago. Deciding to include RCNI practice exam questions in your study plan goes far beyond basic test preparation.

You'll find that our RCNI exam questions frequently feature detailed scenarios and practical problem-solving exercises that directly mirror industry challenges. Engaging with these RCNI sample sets allows you to effectively manage your time and pace yourself, giving you the ability to finish any RUCKUS Certified Networking Implementer Exam practice test comfortably within the allotted time.

Question # 4

Which command will transfer a code image between flash modules, from the primary partition to the secondary partition?

A.

copy disk0 flash TNR08095hufi.bin primary

B.

copy disk0 flash TNR08095hufi.bin secondary

C.

copy flash flash secondary

D.

copy flash flash primary

Question # 5

Which ICX model has eight integrated QSFP28 ports?

A.

ICX7550-48F

B.

ICX7850-48F

C.

ICX7650-48F

D.

ICX7750-48F

Question # 6

Which method is required to install a feature license on an ICX running FastIron 08.0.95?

A.

USB

B.

CLI

C.

TFTP

D.

FTP

Question # 7

A Core, Aggregation, Edge topology network is running Rapid Spanning Tree Protocol (RSTP). Two switches at the edge are legacy and run 802.1D.

To influence the convergence time of the legacy switches at the edge, where are the timers modified?

A.

the route-only port on the upstream gateway

B.

on the two legacy 802.1D switches at the edge

C.

on the Aggregation switches connected to the legacy edge switches

D.

on the root bridge at the core

Question # 8

Which two commands display Power over Ethernet (PoE) power budget? (Choose two.)

A.

show configuration

B.

show inline power

C.

show version

D.

show chassis

E.

show inline power detail

Question # 9

When using zero-touch stacking, which two prerequisites must be in place to ensure all devices join the stack? (Choose two.)

A.

configure each unit's management IP, VLANs, and tagging

B.

enable stacking on all devices

C.

enable stacking on the active controller

D.

ensure units have clean configurations

E.

issue stack disable on intended member devices

Question # 10

What is one advantage of the supportsave command versus the show tech-support command?

A.

Uses fewer CPU cycles during execution.

B.

Allows the transfer of collected data to TFTP.

C.

Uploads directly to RUCKUS support.

D.

Generates automatically after a system crash.

Go to page: