A customer has restricted the AP and antenna combinations for a design to be limited to one model integrated antenna AP for carpeted spaces and one model external antenna AP with high gain antennas for industrial, maintenance, or storage areas. When moving between a carpeted area to an industrial area, the engineer forgets to change survey devices and surveys several APs. Which strategy will reduce the negative impact of the design?

A university wants to deploy a high density of APs in an area where a high number of users congregate. Which functionality allows the university to optimize the RF settings tor APs that operate In different environments or coverage zones?

An engineer is performing an active survey of a network that must support different types of mobile devices. The devices must be able to run an application that requires a minimum RF of 73 dBm. Which mobile device must be used for the survey?

A customer has a centralized wireless deployment with N+1 high availability and few open authentication SSIDs configured. After fail over, all APs are broadcasting all SSIDs, but the clients are assigned IP addresses from a different subnet. The WLANs on both WLCs are configured with the same dynamic interfaces. Which feature must be incorporated in the wireless design of the second controller?

Which survey type relies on predictive models of RF behavior based on building floor plans and

materials, without physically measuring signals?

An engineer added an AP to a deployment after a post-installation site survey. The engineer then notices an increase in co-channel interference and retransmissions. Which two features help mitigate the issue? (Choose two.)

An engineer must install an outdoor wireless network for an area with a direct line of sight. The outdoor APs are in an open area with of harsh weather. Which two parameters must the engineer consider to prevent an outdoor wireless outage? (Choose two.)

When designing for voice over WLAN, what is the recommended cell overlap percentage between adjacent APs?

A company has 10 access point licenses available on their backup Cisco WLC and their primary Cisco WLC is at full capacity, 5 access points are set to high failover priority and 7 access points are set to critical failover priority. During a failure, not all critical access points failed over to the backup Cisco WLC. Which configuration

is the cause of this issue?

An engineer is reducing the subnet size of the corporate WLAN by segmenting the VLAN into smaller subnets. Clients will be assigned a subnet by location. Which type of groups can the engineer use to map the smaller subnets to the corporate WLAN?